LOGR-S | CONFIGURING SINGLE ENDED ANALOG SENSOR

To configure an Analog Single Ended Sensor to the LOGR-S:

1. Navigate to Sensors > Analog Channels

2. Select Configure on desired channel

   • Select Sensor Type from dropdown

   • Description will auto-populate – edit if needed

   • Enter slope and offset (depending on sensor – this will auto-populate)

   • Enter Serial number (if needed)

   • Enter Height of sensor

   • Enter Elevation Angle (if needed)

   • Enter Azimuth Angle (if needed)

3. Select Done

4. Select Save on Analog Channels page

5. Listen for an audible alert (two beeps) from the LOGR-S confirming channel configuration

6. Confirm sensor is on correct channel on the Sensor Outputs page