Skip to navigation Skip to content
Blog

Viewing Posts in "Engineering + Technology"

ZephIR SCADA integrated with ENERCON

As the wind industry’s adoption of Lidar technology continues to grow, Doppler Lidar has been gaining ground as a more flexible, lower-cost, and safer option for hub-height measurements than lattice towers.

Read more

2020 0610 Bat Deterrent System 2

Duke Energy Renewables recently published an article on their Illuminations website chronicling their experience with bat conservation and NRG's Bat Deterrent Systems.

Read more

FlightCage3 1

Bats are notoriously difficult to study due to their small size, nocturnal habits, and penchant for hiding during daylight hours. Therefore, we were particularly excited when researchers from the National Renewable Energy Laboratory (NREL) asked NRG to take part in an innovative study exploring how bats interact with ultrasonic acoustic deterrents.

Read more

Sites 353012 2020 03 01 to 2020 03 02 Average

There are several improvements introduced in the BP60 Barometric Pressure Sensor, but perhaps the most important is the introduction of native temperature-compensation.

Read more

ZX jacket winter field web ready

With numerous Lidar technologies used for wind measurement today, it is fair to wonder which device is best suited for use in cold climates. ZX Lidars has spent a considerable amount of time analyzing how their Doppler Lidar technology, ZX 300, performs in clear-air, low-backscatter conditions typical of high latitudes.

Read more

NRG S1 PP 2

For applications within the wind energy industry, it is critical to capture wind speed data that fall within the power curve of the various turbine models being considered for the project, so that an accurate estimate of future energy production can be calculated from the wind speed data set.

Read more

SR30 config

Read on for an overview of the latest software releases for the SymphoniePRO Data Logger, SymphoniePRO Desktop Application (SPD), which is now at version 3.8.1.

Read more

LargeNRG S1

With the introduction of the NRG S1 Anemometer in August 2019, NRG Systems conducted a round-robin S1 calibration study. The intent of the study was to quantify in a transparent way the differences in calibration results that NRG customers should expect from the three industry-leading wind tunnels that provide calibrations for NRG anemometers.

Read more

200P On Boom 1

We would like to inform you that NRG Systems is preparing to retire the 110S Temperature Sensor and the 200P Wind Vane.

Read more

ZX Opening Tech Support 21

In 2018, ZephIR Lidar became ZX Lidars. This shift represented much more than a rebrand for the UK-based company, which provides a range of industry-leading wind Lidar products.

Read more