Tools required for installation of NRG TallTower

• ¼ inch nut driver (for sensor installation)
• 5/16 inch nut driver (for hose clamps)
• 7/16 inch nut drivers (for wire rope clips) – one per crew member
• Large adjustable wrench or channel lock (for large bolts)
• 9/16 inch wrench, socket or open (for base plate assembly)
• Piece of rebar or similar (for turning anchors)
• Hand sledge (for ground rods)
• Small adjustable wrench (for opening/closing quick links, acorn clamps)
• Small pliers (for sensor cotter pins)
• Small Phillips head (+) screwdriver (for set screws)
• Flat (-) screwdriver (for antenna mounting assembly)
• Knives (to cut electrical tape) – one per crew member
• Level, preferably with a magnetic base (to straighten the tower)
• Compass (for aligning direction sensors)
• Permanent marker (for labeling lower ends of cables)
• Extra 12 V deep cycle marine battery (for winch)