NRG 200M Wind Vane | Initial Setup

1. Lay out cables and required tools:
   
   Small pliers
   Small NRG screw driver
   Phillips screw driver
   ¼” nut driver 
   
   
   
   
   
2. Remove sensor from box.
   
   
   
   
   
3. Pull cable-ends through the small opening in the boot and remove cotter pin.
   
   
   
   
   
4. Connect the sensor to the cable. Wire the cable into the data logger.
   
   
   
   
   
5. Mount sensor on boom. Insert cotter pin. Tighten set screw.