LOGR-S | CONFIGURING SERIAL CHANNELS

To configure Serial Channels to already configured Serial Sensors 

1. Navigate to Sensors > Serial Channels

Note: When configuring and saving a Serial Sensor, the Serial Channels page will automatically open  

2. Select Sensor from dropdown

Note: Only configured Serial Sensors will be available for selection in dropdown

3. Select desired Measurand from dropdown

Note: Only available measurand for the selected sensor will be available for selection in dropdown

4. Slope value populates automatically based on selected sensor and measurand combination. Edit if needed.

5. Offset value populates automatically based on selected sensor and measurand combination. Edit if needed.

6. Select Save

7. Listen for an audible alert (two beeps) from the LOGR-S confirming sensor and measurand have been enabled

8. Confirm sensor and specific measurand are on desired channel via the Sensor Outputs page